Friday, 22 October 2010

Pinhole Camera






   How We Created Our Pin-hole Camera
  • We first had to eat all of the pringles.
  • The we made sure that the inside of the pringles tube was 'light-tight' by painting the inside of it black.
  • The inside of the tube then had to be dryed.
  • We then gave it a secound coat of paint and dryed it for the last time. (so it was completely black)
  • Then it was time to make the main part of the pin-hole camera, which was the hole which we had to cut out half-way down our pringles tube/container, this hole then had to be sealed using cling-film.
  • The card-board flap was then built so we could distinguish a way of letting the light in and stopping it getting in our pringles tube. A piece of gaffa tape was attached to it for easy open/close.
  • A tiny hole was cut into the tin-foil (pin-hole).
  • Before we could begin taking pictures with our home-made camera we had to load the camera with photographic paper, we had to place it inside the tube with the shiney side facing the pin-hole.
  • Finally we sealed up the lid with even more gaffa tape. This had to be done everytime we wanted to take a new image/ re-load our camera.

No comments:

Post a Comment